Knowledge

Home/Knowledge/Details

Daily maintenance and management of dehydration equipment

Machines used for sludge dewatering include vacuum filters, belt filter presses, plate and frame filter presses, and centrifuges. Belt filter presses are the most commonly used. The following explains the daily maintenance and management of belt filter presses. During actual operation, the dewatering machine's operating status should be adjusted continuously based on changes in the incoming sludge quality. Mechanical dewatering process control primarily involves:

Belt speed control: The belt's travel speed controls the dewatering time in each working zone, affecting the solids content, thickness, and ease of cake removal. Lower belt speeds increase the solids content and thickness of the cake, making it easier to remove from the belt. Conversely, higher belt speeds decrease the solids content and thinner the cake, making it more difficult to remove. Therefore, from a cake quality perspective, lower belt speeds are preferred. However, belt speed directly affects the dewatering machine's processing capacity: lower belt speeds reduce processing capacity.

Belt tension control: Generally speaking, higher belt tension increases the solids content of the cake. However, excessive tension can squeeze the sludge out of the filter belt in low- or high-pressure zones, causing it to escape or be pushed into the filter belt, leading to clogging.


Controlling Conditioning: Sludge conditioning directly impacts dewatering performance. Belt filter presses and dewatering machines are more dependent on conditioning. If the dosage is insufficient, conditioning will be poor, preventing the capillary water in the sludge from converting into free water and being removed by gravity, making it impossible to press the sludge. Conversely, excessive dosage increases treatment costs and, more importantly, increases sludge viscosity, making the filter belt susceptible to clogging.

 

Analysis of Abnormal Problems During Belt Filter Press Operation: Causes and Solutions:

-Decreased Cake Solids Content and Reduced Solids Recovery

 

Causes and Solutions: Poor conditioning is generally caused by insufficient dosage. If the influent sludge quality changes and dewatering performance declines, retesting should be performed. Determine the appropriate dosage for dry sludge. Sometimes, this is due to improper chemical dosing, where the concentration is too high, preventing the flocculant from fully dissolving. Even with sufficient chemical dosage, the conditioning effect is poor. Sometimes, improper dosing placement can lead to flocculation times that are too long or too short. Experimentation and adjustments should be conducted.

 

Excessive belt speed. Excessive belt speed thins the sludge cake, resulting in a decrease in solids content. The belt speed should be reduced promptly.

 

Insufficient belt tension. This fails to provide sufficient squeezing and shearing forces, reducing the solids content. The tension should be increased appropriately.

 

-Lower solids content in the sludge cake and lowering the solids recovery rate.

 

Causes and Solutions: Filter belt clogs. A clogged filter belt prevents water from being filtered out, reducing the solids content. Stop operation and flush the filter belt.

 

Excessive belt speed causes material to escape from the squeeze zone. The belt speed should be reduced appropriately.

 

Insufficient belt tension causes material to escape from the squeeze zone, forcing some sludge through the filter belt and out with the filtrate. The tension should be reduced.

 

There are also problems such as filter belt slipping, filter belt often deviating, filter belt serious blockage, etc. When problems occur, they should be adjusted and the problems should be solved in time without affecting normal operation.